2 - Hands-Free Pumps. 2 - Collection Containers. 2 - Breast Shields (24mm). 4 - Pairs of Silicone Inserts (15 mm, 17 mm, 19 mm, 21 mm). 2 - Diaphragm. 2 - Valves (duckbill). 2 - Bra Strap Adjusters. 2 - USB-C cables. 2 - Dust Covers. 1 - Cleaning Bru
Yes, but coverage will vary depending on your specific insurance plan. To find a supplier who can help get your Motif Aura Glow through insurance, use the Motif Insurance Lookup Tool.
The Motif Aura Glow has 4 modes: Massage Mode, Expression Mode, Cluster Feeding Mode and General Pumping Mode. The Motif Aura Glow has 9 levels within Massage Mode, Expression Mode and General Pumping Mode. There are 5 levels within Cluster Feeding M
It is important to properly align the nipples into the center of the flange and have the pump firmly pressed against the breast to make a suction seal. If the pump is loosely fit, the suction generated from the pump may leak and cause a low to no suc
Align the center of the breast shield with the center tunnel of the collection container and press firmly to seal. Then, secure the breast shield to the rim of the collection container. Run your fingers along the entire rim to ensure the breast shiel
Yes, always remove the pump motor before you pour the milk out to avoid damaging the motor.
Yes, you can adjust the nightlight brightness on your Motif Aura Glow. Press and hold the nightlight button to adjust the light brightness to your preferred level. Then, short press to turn on or off. The pump remembers the light setting. Note: The n
The Motif Aura Glow is not supported by the Motif Aura app. The Motif Aura app is designed to pair with the original version of the Motif Aura.
The Motif Aura Glow is BPA, PVC, DEHP, and phthalates free.
The Motif Aura Glow collection containers hold 6 oz. of breast milk.
If the pump is fully charged, it will last approximately 90 minutes.
No, you cannot pump while charging your Motif Aura Glow. We recommend charging the pump when there is only 1 bar on the battery display and it is blinking.
Hold down the play/pause button to turn the pump on. Short press the play/pause button to start the pump. Hold down the play/pause button to turn off the pump.
Designed with a lactation consultant, Cluster Feeding Mode is a mini power pumping mode that imitates a newborn’s cluster feeding to help boost milk supply. Cluster feeding naturally occurs when a baby breastfeeds multiple times within a short period
Designed with a lactation consultant, General Pumping Mode is a mode for everyday use that begins in massage mode and switches to expression mode after 2 minutes. This repeats twice for 2 letdowns.
The Motif Aura Glow includes 2 24 mm breast shields and 2 flange inserts each in the following sizes: 15 mm, 17 mm, 19 mm, and 21 mm. 27 mm breast shields and 11 mm, 12 mm, 13 mm, and 14 mm flange inserts are available separately.
Yes, each insert has its size labeled on the outside close to the end of the flange tunnel. Because the size label is the same color as the flange insert itself, you may need to rotate the insert slowly in good lighting to read the size label.
Make sure that the proper flange size is being used. The nipple should not be too tight or loose inside the flange tunnel and the nipple should be able to pull back and forth easily when pumping. It's essential that a good seal is created between the
A bra that is tight enough to firmly hold and press the pump against the breast for a complete seal. We recommend an adjustable bra with some support. Please see section 9.3 of the product manual for instructions on how to position the pump in your b
When using the Motif Aura Glow, the pour spout stopper may come loose. While the stopper is designed to prevent milk from spilling, it is also designed to allow air to escape. Air must leave the collection container to allow milk to flow through the
If there's a loss of suction while pumping, it could be for a variety of reasons. Follow the instructions below to diagnose the issue. Test pump motor:. Separate the main body from the Collection Container, put the main body in the palm of your hand,
To sterilize parts, place all pump parts (except motor) in a pot and cover them with water.Bring to a boil and let boil for 5 minutes.Remove all parts with clean tongs.Place parts on a clean paper towel or dish towel and allow to air dry completely
Please note: It is not recommended to wash and dry Motif breast pump parts in the dishwasher. There is no standard temperature for dishwashers and some may warp parts. Parts damaged in the dishwasherare not covered under warranty. Please see product
All Motif pumps come equipped with everything mom needs to start pumping right away, including 2 slow flow nipples.
How to Assemble Your Motif Aura Glow FAQ:. 1. Make sure that you clean the pump as instructed in this user manual. To avoid any milk leakage, remove any residue around the rim before assembling and make sure all breast pump parts are dry. Wash your h